Detection areas and items
Set where to look, what to look for, and when to look.
This is the most important screen in this solution. If these settings are off, detections are caught in the wrong places or not at all.
Open the Device Settings tab to see the camera list on the left and that camera's settings on the right.
1. Enter the location
Enter where the camera is looking, such as Section 3, Building A, 5F. This value decides where to go when you receive a detection alert. Use wording that people on site can hear and find right away.
2. Draw the areas
Click points on the camera frame to draw a polygon.
Place points
Each click on the frame adds a vertex.
Close
After placing three or more points, click the first point again or double-click to close the polygon.
Edit
Drag a vertex to move it. If you placed one by mistake, undo with Ctrl + Z.
Detection area and restricted area
| Type | What it is | If not drawn |
|---|---|---|
| Detection area | Watches only inside | The whole frame is watched |
| Restricted area | Alerts when someone enters | Those items do not run |
- Items that use the detection area: PPE, fire, fall, work at height, safety harness, heavy equipment proximity
- Items that use the restricted area: Restricted area entry, after-hours entry
Draw only one of each type.
You must draw a restricted area
If you turn on restricted area entry or after-hours entry without drawing the area, those items detect nothing even while they are on.
When drawing the detection area
- If a road outside the site or a neighboring building is in the frame, leave that part out. Passing people and vehicles will keep getting caught.
- Leave out places where people are always present, such as material storage yards, if needed.
- If you draw it too narrow, you miss the work zone you actually need to watch.
3. Turn on detection items
Turn the eight items on and off with switches, grouped into Work environment and Workers. It is better to turn off hazards that do not exist on this site. False detections go down.
Additional AI instructions
You can write instructions for each item. If you describe the site's conditions in sentences, the AI takes them into account.
- "This site uses only white and yellow hard hats"
- "The 3rd floor is a material delivery zone, so people stay there for long periods"
- "Only the signal person enters within 5 meters of the excavator"
4. Set the working hours
Set the start and end times in 30-minute steps. Each item uses this value differently.
| Item | When it runs |
|---|---|
| Fire · Smoke | 24 hours a day |
| After-hours entry | Only outside working hours |
| The other six items | Only within working hours |
If you enter the working hours wrong, nothing is detected during the day, or after-hours entry floods in all night. Match them to the site's actual working hours.
5. Detection image type
The form of the snapshot kept on the detection card.
- Original: The camera frame as is
- Video layout applied: The frame with the detection results drawn on it
The second option is better for seeing at a glance what was caught and why.
Custom missions
Detection items needed only on your site, beyond the eight standard items. You can enter a name and instruction sentence only when an admin has enabled it.
If it is locked, "Contact your admin to use this item" is displayed.